Easy, Green, Home Improvement Project That Will Make Your Life
a Bit Easier and Save You Tons of Water and Money!
A great do it yourself home improvement project that provides you with the convenience of fast hot water, saves you water, time, energy, and
money, and makes your plumbing system green.
Installing a green water conservation product that not only saves water, but adds convenience for you...no more standing there
waiting for the shower to get hot!
At the touch of a button, the Chilipepper pumps hot water from your water heater to your sink, or shower, while sending the cooled off
hot water back to the water heater through the cold water piping.
Since it saves a whole lot of water and costs about $2 per year
in electricity, it is definitely a green home improvement product.
This easy home improvement project addresses the problem of long delays to get your hot water.
The Chilipepper is a small powerful micro-processor controlled pump
that installs under your sink.
When you push the start button, the Chilipepper pumps the water in a big loop
from the water heater through the hot water piping to the Chilipepper, and
on through the cold water piping back to the water heater inlet. A
big loop.
When the electronic control circuitry detects an increase in the water temperature inside the pump, it shuts the pump off. The shut-off
sensitivity is adjustable with a knob on the front of the Chilipepper.
When the circuitry detects a temperature over 100 degrees it locks out the pump.
Get your hot water faster!
The Chilipepper has a very powerful motor for its size. The Chilipepper
pumps water at about 3 gallons per minute in a typical residential
setting.
Many fixtures are now low flow meaning they restrict flow to as
little as 3/4 gallons per minute. Thus in many cases the Chilipepper can
cut the time it takes to get hot water to 1/3 to 1/2 the wait.
Save Water!
Since no water gets run down the drain while you
wait for hot water, you save significant amounts of water every time you use the
Chilipepper.
More about saving water
Save energy!
If you leave your hot water fixture running and go do something else while you
wait for it, and you come back to find it is hot, then any hot water you've run
down the drain was wasting energy! And the energy to heat the water is far
more expensive than the water itself.
Improve the performance of your dishwasher!
The number one cause of poor dishwasher performance is water that is not hot enough on the first cycle. By using
the Chilipepper before you start your dishwasher you will get full temperature hot water to your dishwasher on the first cycle...and hot water is much better
at dissolving detergent and cleaning dishes than cold water. This simple easy to install home improvement product will get
your dishwasher full temperature water right off the bat, resulting in cleaner dishes.
Remote control - more convenience
Remote operation of the Chilipepper provides even
greater convenience. Place the remote transmitter next to your bed. When your
alarm goes off, hit the start button and by the time you get to the
bathroom the hot water will already be there!
It's as easy as plugging in a lamp. Just plug the
Receiver into an outlet near the Chilipepper, and connect the control
cable to them. Now plug the wireless remote button into any
convenient 110 volt outlet. You're ready to go.
Just push the button.
If the Chilipepper is providing hot water to more
than one location, the wireless remote is the ideal way to operate the
Chilipepper from various locations. Just plug a wireless remote
button into a convenient outlet.
Chilipepper Hot Water Demand System PumpChilipepper Sales 1380 Greg St., # 221 Sparks Nevada, 89431
PH (775)-359-1223
